Skip to content
Fault code dictionary (DTC)

B2450 — Auxiliary heater glow plug circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected an open circuit in the glow plug of the auxiliary heater, the fuel-fired heater that warms the cabin or the coolant. This code is manufacturer-defined. The circuit is broken, so the glow plug gets no current and the heater may not light.
FamilyBody (B)

Typical symptoms

Auxiliary heater does not start
Cabin warms up little or slowly from cold
Warning light or message about the heater
Repeated start attempts with no result

Common causes

Burnt-out or open glow plug
Connector unplugged or corroded
Broken wire
Blown fuse
Faulty heater control unit

What to do

Have the glow plug, connector and wiring checked, and check the fuse. You can use the car normally, but cold-weather heating will be reduced. It is not a safety emergency.

How to read code B2450

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B2450 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B2450 mean?

Auxiliary heater glow plug circuit open. The control unit has detected an open circuit in the glow plug of the auxiliary heater, the fuel-fired heater that warms the cabin or the coolant. This code is manufacturer-defined. The circuit is broken, so the glow plug gets no current and the heater may not light.

Can I keep driving with code B2450 active?

With caution: limp mode possible, have it checked soon

Common causes — B2450

Burnt-out or open glow plug Connector unplugged or corroded Broken wire Blown fuse Faulty heater control unit

How do you fix code B2450?

Have the glow plug, connector and wiring checked, and check the fuse. You can use the car normally, but cold-weather heating will be reduced. It is not a safety emergency.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes