155 — Fuel Injector Activation Cyl 3
| Meaning | Fuel Injector Activation Cyl 3. |
| System | DME 7.2 |
| Family | Manufacturer-native code |
How to read code 155
Code 155 is a native BMW code of the "DME 7.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 155 mean?
Fuel Injector Activation Cyl 3. (System: DME 7.2)
Can I keep driving with code 155 active?
With caution: limp mode possible, have it checked soon
How do you fix code 155?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DME 7.2)
- 1 — Leak Diagnosis Pump
- 10 — Lambda Sensor Pre Cat Bank 1 Signal
- 101 — Torque Monitoring
- 102 — Multifunction Steering Wheel Signal
- 103 — Control Unit Monitoring
- 104 — Clutch Switch Signal
- 105 — Control Unit Fault (RAM)
- 106 — Brake Switch Signal
- 107 — Control Unit Fault (ROM)
- 108 — Reset DME / Voltage Supply
- Previous code: 154 — Lambda Pre Cat Bank 2 Min Limit
- Next code: 156 — Fuel Injector Activation Cyl 7
Related codes
- 15 — Exhaust Gas Recirculation
- 15 — Voltage Supply DDE
- 15 — DDE Power Supply Main Relay
- 15 — "CHECK ENGINE" Light Failure
- 15 — Lambda Sensor Timing Pre Cat Bank 1 (TP)
- 15 — EWS
- 15 — Plausibility Cut Out Time
- 150 — Knock Sensor 1
- 150 — Fuel Injector Activation Cyl 1
- 150 — Lambda Post Cat Bank 1 Max Limit
- 151 — Knock Sensor 2
- 151 — Fuel Injector Activation Cyl 5