229 — Pedal Travel Sensor Comparison
| Meaning | Pedal Travel Sensor Comparison. |
| System | DME 7.2 |
| Family | Manufacturer-native code |
How to read code 229
Code 229 is a native BMW code of the "DME 7.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 229 mean?
Pedal Travel Sensor Comparison. (System: DME 7.2)
Can I keep driving with code 229 active?
With caution: limp mode possible, have it checked soon
How do you fix code 229?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DME 7.2)
- 1 — Leak Diagnosis Pump
- 10 — Lambda Sensor Pre Cat Bank 1 Signal
- 101 — Torque Monitoring
- 102 — Multifunction Steering Wheel Signal
- 103 — Control Unit Monitoring
- 104 — Clutch Switch Signal
- 105 — Control Unit Fault (RAM)
- 106 — Brake Switch Signal
- 107 — Control Unit Fault (ROM)
- 108 — Reset DME / Voltage Supply
Related codes
- 22 — Idle Speed Controller
- 22 — Lambda Sensor Timing Pre Cat Bank 2 (TV)
- 22 — Injector Fault Cylinder 3
- 22 — Fuel Injector Cyl 3
- 220 — EWS 2 Immobilisation
- 220 — CAN Timeout (EGS/AGS)
- 220 — Lambda Voltage Range Bank 1 Sensor 1
- 221 — CAN Timeout ASC/DSC
- 221 — Lambda Voltage Range Bank 2 Sensor 1
- 222 — CAN Timeout Instrument Cluster
- 222 — Low Coolant Temperature or Lambda Sensor Control (MS43)
- 223 — CAN Timeout ACC