2F85 — Control module Internal fault Internal Temperature Sensor
| Meaning | Control module Internal fault Internal Temperature Sensor. |
| System | ME 9 |
| Family | Manufacturer-native code |
How to read code 2F85
Code 2F85 is a native BMW code of the "ME 9" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 2F85 mean?
Control module Internal fault Internal Temperature Sensor. (System: ME 9)
Can I keep driving with code 2F85 active?
With caution: limp mode possible, have it checked soon
How do you fix code 2F85?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ME 9)
- 2712 — DMTL Solenoid Valve Activation
- 2713 — Lambda Sensors Pre Cat Swapped
- 2714 — Lambda Sensor Heater Post Cat Bank 2
- 2715 — Lambda Sensor Heater Pre Cat Bank 2
- 2716 — Lambda Sensor Heater Post Cat Bank 1
- 2717 — Lambda Sensor Heater Post Cat Bank 2
- 2718 — Crankshaft Sensor Reference
- 2719 — Crankshaft Sensor Period
- 271A — Lambda Sensor Pre Cat Bank 1 Signal
- 271C — Lambda Sensor Post Cat Bank 1 Signal
- Previous code: 2F76 — Control Module Internal Fault Ambient Pressure Sen...
- Next code: 2F8A — Power Supply
Related codes
- 2F — Crankshaft Sensor
- 2F08 — Intake Air Temperature Sensor Signal
- 2F12 — AirCon Compressor Relay
- 2F17 — Engine Oil Temperature too High
- 2F44 — EWS Intervention
- 2F45 — EWS Data Line
- 2F46 — EWS Calibration
- 2F4E — Road Speed Signal
- 2F62 — Brake Light Switch
- 2F67 — Clutch Switch
- 2F76 — Control Module Internal Fault Ambient Pressure Sensor
- 2F8A — Power Supply