P1476 — Leakage Diagnostic Pump Clamped Tube
| Meaning | Leakage Diagnostic Pump Clamped Tube. |
| Family | Powertrain (P) |
How to read code P1476
Code P1476 is a native BMW code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is an informational entry: it normally does not limit how the vehicle works.
The code P1476 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (76) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1476 mean?
Leakage Diagnostic Pump Clamped Tube.
Can I keep driving with code P1476 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1476?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1475 — Leakage Diagnostic Pump Reed Switch Did Not Close
- Next code: P1477 — Leakage Diagnostic Pump Reed Switch Did Not Open
Related codes
- P1400 — Heated Catalyst Battery Voltage or Current Too Low During He...
- P1401 — Heated Catalyst Current Too High During Heating Bank 1
- P1402 — Heated Catalyst Power Switch Overtemperature Condition Bank...
- P1403 — Carbon Canister Shut Off Valve Control Circuit Electrical
- P1404 — Heated Catalyst Current Too High During Heating Bank 2
- P1405 — Heated Catalyst Power Switch Overtemperature Condition Bank...
- P1406 — Heated Catalyst Internal Control Module Checksum ROM Error
- P1413 — Secondary Air Injection Pump Relay Control Circuit Signal Lo...
- P1414 — Secondary Air Injection System Monitor Circuit High
- P1420 — Secondary Air Valve Control Circuit Electrical
- P1421 — Secondary Air System Bank 1
- P1422 — Secondary Air System Bank 2