P1290 — CNG Fuel Pressure Too High
| Meaning | CNG Fuel Pressure Too High. |
| Family | Powertrain (P) |
How to read code P1290
Code P1290 is a native Dodge code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1290 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1290 mean?
CNG Fuel Pressure Too High.
Can I keep driving with code P1290 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1290?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P128E — TCM POWER CONTROL CIRCUIT 2 OVERCURRENT
- Next code: P1291 — No Temp Rise Seen From Fuel Heaters
Related codes
- P1243 — Open Or Shorted Condition Detected In The Turbocharger Surge...
- P125A — POWER ENABLE CONTROL CIRCUIT LOW
- P125B — POWER ENABLE CONTROL CIRCUIT HIGH
- P1272 — A/C CLUTCH CONTROL CIRCUIT 2 LOW
- P1273 — A/C CLUTCH CONTROL CIRCUIT 2 HIGH
- P1274 — A/C CLUTCH CONTROL CIRCUIT 2 OPEN
- P1275 — A/C CLUTCH CONTROL CIRCUIT 2 OVERCURRENT
- P1277 — STARTER CONTROL CIRCUIT 2 LOW
- P1278 — STARTER CONTROL CIRCUIT 2 HIGH
- P1279 — STARTER CONTROL CIRCUIT 2 OPEN
- P127A — STARTER CONTROL CIRCUIT 2 OVERCURRENT
- P127C — FUEL PUMP CONTROL CIRCUIT 2 LOW