P1499 — Open Or Shorted Condition Detected In The Hydraulic Cooling Fan Solenoid Control
| Meaning | Open Or Shorted Condition Detected In The Hydraulic Cooling Fan Solenoid Control. |
| Family | Powertrain (P) |
How to read code P1499
Code P1499 is a native Dodge code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1499 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (99) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1499 mean?
Open Or Shorted Condition Detected In The Hydraulic Cooling Fan Solenoid Control.
Can I keep driving with code P1499 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1499?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1498 — High Speed Rad Fan Ground CTRL Rly Circuit
- Next code: P1506 — CRANKCASE DEPRESSION REGULATOR VALVE PERFORMANCE
Related codes
- P1403 — Loss Of 5 Volts To EGR Sensor
- P141A — EXHAUST GAS TEMPERATURE SENSOR 1 AND 2 SIGNALS SWAPPED
- P144E — EGR COOLER BYPASS STATUS LINE CIRCUIT LOW
- P144F — EGR COOLER BYPASS STATUS LINE CIRCUIT HIGH
- P1451 — DIESEL PARTICULATE FILTER SYSTEM PERFORMANCE
- P1475 — Auxiliary 5 Volt Output Too High
- P1476 — Too Little Secondary Air
- P1477 — Too Much Secondary Air
- P1478 — Battery Temp Sensor Voltage Out Of Limit
- P1479 — Transmission Fan Relay Circuit Open Or Shorted
- P1480 — PCV Solenoid Valve Open Or Shorted
- P1481 — EATX RPM Pulse Generator Signal For Misfire Detection