P1693 — DTC Detected In ECM Or PCM
| Meaning | DTC Detected In ECM Or PCM. |
| Family | Powertrain (P) |
How to read code P1693
Code P1693 is a native Dodge code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1693 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (6) points to computer and output circuits, and the last two (93) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1693 mean?
DTC Detected In ECM Or PCM.
Can I keep driving with code P1693 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1693?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1691 — Fuel Injection Pump Controller Calibration Failure
- Next code: P1694 — No CCD Messages Received From ECM
Related codes
- P1602 — PCM Not Programmed
- P1679 — CALIBRATION NOT LEARNED
- P1680 — Clutch Released Switch Circuit Open Or Shorted
- P1681 — No Instrument Panel Cluster CCD/J1850 Messages Received
- P1682 — Charging System Voltage Too Low
- P1683 — Speed Control Power Relay Or Speed Control 12 Volt Driver Ci...
- P1684 — BATTERY WAS DISCONNECTED
- P1685 — Skim Invalid Key
- P1686 — No SKIM Bus Message Received
- P1687 — No Cluster Bus Message
- P1688 — Internal Fuel Injection Pump Controller Failure
- P1689 — No Communication Between ECM & Injection Pump Module