P1224 — Fuel metering control
| Meaning | Fuel metering control. |
| Family | Powertrain (P) |
How to read code P1224
Code P1224 is a native Mercedes-Benz code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1224 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (24) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1224 mean?
Fuel metering control.
Can I keep driving with code P1224 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1224?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1223 — Distributer shaft position sensor Y23/2|2
- Next code: P1225 — Intake pressure control
Related codes
- P1220 — Fuel metering control Y23/1
- P1221 — CAN communication if faulty.Fault of ETC over CAN
- P1222 — accelerator pedal position sensor B37
- P1223 — Distributer shaft position sensor Y23/2|2
- P1225 — Intake pressure control
- P1226 — Cam ring position sensor Y23/2|1
- P1227 — Distributer shaft position sensor Y23/2|2
- P1228 — Injection pump quantity stop
- P1229 — Balancing resistor Y23/2r2
- P1230 — Cam ring position sensor Y23/2|1
- P1233 — Throttle valve actuator jamming (iced up) M16/6
- P1234 — accelerator pedal position sensor B37