P1605 — ABS RPM sensor bad channel identification CAN BUS acceleration signal
| Meaning | ABS RPM sensor bad channel identification CAN BUS acceleration signal. |
| Family | Powertrain (P) |
How to read code P1605
Code P1605 is a native Mercedes-Benz code: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1605 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (6) points to computer and output circuits, and the last two (05) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1605 mean?
ABS RPM sensor bad channel identification CAN BUS acceleration signal.
Can I keep driving with code P1605 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1605?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1604 — CAN link to AAC
- Next code: P1610 — Actuation of holding relay Relay Supply voltages s...
Related codes
- P1603 — CAN of EIS
- P1604 — CAN link to AAC
- P1610 — Actuation of holding relay Relay Supply voltages switches of...
- P1611 — Control module
- P1612 — Control module Kl 15
- P1613 — Control module
- P1614 — Control module or fuel metering control or fuel rack sensor...
- P1615 — Control module supply voltage
- P1616 — Control module
- P1617 — Control module or not coded
- P1618 — Control module
- P1619 — Control module or not coded