Skip to content
Fault code dictionary (DTC)

P0201 — Injector cylinder 1: circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe electrical control of the first cylinder's injector is not responding correctly. Sister codes P0202, P0203 and P0204 cover the other cylinders.
FamilyPowertrain (P)

Typical symptoms

Engine shaking or misfiring
Rough idle
Reduced power
Smoke from the exhaust

Common causes

Loose or corroded injector connector
Heat-damaged wiring
Faulty injector coil or piezo element
Faulty ECU output stage

What to do

Measure injector resistance and wiggle-test the harness with the engine running: many cases are a connector, not an injector. If the injector is replaced, remember to program its IMA/IQA code into the ECU.

How to read code P0201

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0201 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (01) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0201 mean?

Injector cylinder 1: circuit. The electrical control of the first cylinder's injector is not responding correctly. Sister codes P0202, P0203 and P0204 cover the other cylinders.

Can I keep driving with code P0201 active?

With caution: limp mode possible, have it checked soon

Common causes — P0201

Loose or corroded injector connector Heat-damaged wiring Faulty injector coil or piezo element Faulty ECU output stage

How do you fix code P0201?

Measure injector resistance and wiggle-test the harness with the engine running: many cases are a connector, not an injector. If the injector is replaced, remember to program its IMA/IQA code into the ECU.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes