P05C7 — Economy mode switch circuit open
| Meaning | The control unit detected that the electrical circuit of the Eco mode button is open or broken. It no longer gets a valid signal from the button, so it cannot tell whether you asked for economy mode or not. |
| Family | Powertrain (P) |
Typical symptoms
Eco mode switches on or off by itself
Check engine light on
Eco message or symbol does not match your choice
Throttle response feels different than usual
Common causes
Broken wire or poor contact in the switch wiring
Worn or damaged switch, for example from spilled liquid
Faulty ground or supply to the circuit
Faulty control unit (rare)
What to do
How to read code P05C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P05C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P05C7 mean?
Economy mode switch circuit open. The control unit detected that the electrical circuit of the Eco mode button is open or broken. It no longer gets a valid signal from the button, so it cannot tell whether you asked for economy mode or not.
Can I keep driving with code P05C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P05C7
Corroded or loose switch connector Broken wire or poor contact in the switch wiring Worn or damaged switch, for example from spilled liquid Faulty ground or supply to the circuit Faulty control unit (rare)
How do you fix code P05C7?
Press the button several times and check that the connector under the dash or at the button is seated and clean. This will not stop the car, but have the circuit tested with a diagnostic tool soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P05C6 — Engine coolant pressure sensor circuit intermitten...
- Next code: P05C8 — Economy mode switch signal out of range
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance