P05D6 — Driver mode select switch B signal too high
| Meaning | The control unit reads a higher than normal voltage on the circuit of driving mode selector B. This often comes from a broken wire, a missing ground or contact with a power supply. |
| Family | Powertrain (P) |
Typical symptoms
Driving mode does not change
Check engine light on
Mode indication missing or inconsistent
No noticeable difference in engine response
Common causes
Missing or corroded selector ground
Signal wire touching a power supply
Selector with worn internal contacts
Faulty control unit (rare)
What to do
How to read code P05D6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P05D6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (D6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P05D6 mean?
Driver mode select switch B signal too high. The control unit reads a higher than normal voltage on the circuit of driving mode selector B. This often comes from a broken wire, a missing ground or contact with a power supply.
Can I keep driving with code P05D6 active?
With caution: limp mode possible, have it checked soon
Common causes — P05D6
Signal wire broken or disconnected Missing or corroded selector ground Signal wire touching a power supply Selector with worn internal contacts Faulty control unit (rare)
How do you fix code P05D6?
Check the selector connector and its ground, since a lost ground often gives this reading. You can drive, but have the circuit diagnosed as soon as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P05D5 — Driver mode select switch B signal too low
- Next code: P05D7 — Driver mode select switch B signal out of range
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance