P05F6 — Aftertreatment power relay stuck on
| Meaning | The control unit detects that the aftertreatment power relay stays on even when it is commanded off. The connected components remain powered when they shouldn't be. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about an emissions system fault
AdBlue pump still running with the car off
Battery draining when the car sits
Relay not releasing on command
Common causes
Short to positive on the relay output
Faulty or wrong-type relay
Shorted wiring
Fault in the control unit's relay driver
What to do
How to read code P05F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P05F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P05F6 mean?
Aftertreatment power relay stuck on. The control unit detects that the aftertreatment power relay stays on even when it is commanded off. The connected components remain powered when they shouldn't be.
Can I keep driving with code P05F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P05F6
Relay contacts welded together Short to positive on the relay output Faulty or wrong-type relay Shorted wiring Fault in the control unit's relay driver
How do you fix code P05F6?
If the battery goes flat while the car sits, have it checked soon. Test the relay and verify that the connected components don't stay powered with the key off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P05F5 — Aftertreatment power relay control circuit high
- Next code: P05F7 — Aftertreatment power relay stuck off
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance