P0704 — Clutch switch input circuit fault
| Meaning | The control unit found an incorrect signal from the clutch pedal switch, fitted on manual gearbox cars. The switch tells the control unit when the clutch is pressed, for example for starting and some driver-assist functions. The signal may be missing, stuck on, or not consistent with the pedal movement. |
| Family | Powertrain (P) |
Typical symptoms
Cruise control that will not engage or cuts out by itself
Start-stop not working
Check engine light on
Jerking or odd behaviour when changing gear
Common causes
Damaged switch wiring or connector
Pedal or bracket with play
Dirt or moisture in the connector
Faulty control unit or input circuit (rare)
What to do
How to read code P0704
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0704 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (04) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0704 mean?
Clutch switch input circuit fault. The control unit found an incorrect signal from the clutch pedal switch, fitted on manual gearbox cars. The switch tells the control unit when the clutch is pressed, for example for starting and some driver-assist functions. The signal may be missing, stuck on, or not consistent with the pedal movement.
Can I keep driving with code P0704 active?
With caution: limp mode possible, have it checked soon
Common causes — P0704
Worn or misadjusted clutch pedal switch Damaged switch wiring or connector Pedal or bracket with play Dirt or moisture in the connector Faulty control unit or input circuit (rare)
How do you fix code P0704?
First check the clutch pedal switch, its position and its connector. If the car still starts you can use it, but starting could fail from one day to the next. Have it checked soon, especially if you have already had trouble starting.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0703 — Torque converter/brake switch B circuit fault
- Next code: P0705 — Transmission range sensor (PRNDL) circuit fault
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible
- P070C — Transmission fluid level sensor circuit: signal too low