P0986 — Shift Solenoid E Control Circuit High
| Meaning | Shift Solenoid E Control Circuit High. |
| Family | Powertrain (P) |
How to read code P0986
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0986 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (86) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0986 mean?
Shift Solenoid E Control Circuit High.
Can I keep driving with code P0986 active?
With caution: limp mode possible, have it checked soon
How do you fix code P0986?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0985 — Shift Solenoid E Control Circuit Low
- Next code: P0987 — Transmission Fluid Pressure Sensor/Switch E Circui...
Related codes
- P0900 — Clutch Actuator Circuit / Open
- P0901 — Clutch Actuator Circuit Range/Performance
- P0902 — Clutch Actuator Circuit Low
- P0903 — Clutch Actuator Circuit High
- P0904 — Gate Select Position Circuit [senses left / right position]
- P0905 — Gate Select Position Circuit Range/Performance
- P0906 — Gate Select Position Circuit Low
- P0907 — Gate Select Position Circuit High
- P0908 — Gate Select Position Circuit Intermittent
- P0909 — Gate Select Control Error
- P0910 — Gate Select Actuator Circuit / Open [left / right motion]
- P0911 — Gate Select Actuator Circuit Range/Performance