P1218 — CID signal too high
| Meaning | The reference mentions a CID signal that is too high. On some makes CID means cylinder identification, the signal that tells the control unit which cylinder is in phase, but I don't have solid information for every make. The code is manufacturer-defined, so the meaning should be confirmed for the specific model. |
| Family | Powertrain (P) |
Typical symptoms
Rough running
Loss of power
Check engine light on
Seemingly higher fuel use
Common causes
Damaged wiring or connector
Sensor gap or mounting not correct
Damaged or dirty reluctor wheel
Control unit problem, less common
What to do
How to read code P1218
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1218 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (18) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1218 mean?
CID signal too high. The reference mentions a CID signal that is too high. On some makes CID means cylinder identification, the signal that tells the control unit which cylinder is in phase, but I don't have solid information for every make. The code is manufacturer-defined, so the meaning should be confirmed for the specific model.
Can I keep driving with code P1218 active?
With caution: limp mode possible, have it checked soon
Common causes — P1218
Faulty phase or position sensor Damaged wiring or connector Sensor gap or mounting not correct Damaged or dirty reluctor wheel Control unit problem, less common
How do you fix code P1218?
First have the sensor, connector and wiring of the phase signal checked. If the engine runs badly or stalls, avoid using it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1217 — Accelerator pedal sensor C intermittent signal
- Next code: P1219 — CID signal too low
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction