P1220 — Series throttle control system malfunction
| Meaning | The control unit reported a fault in the system that operates the air throttle, described as a "series" system. This code is manufacturer-defined and I don't have solid information on the exact meaning for every make. In general it concerns the command and control of the electronic throttle. |
| Family | Powertrain (P) |
Typical symptoms
Engine in reduced-power mode
Rough idle
Loss of power
Check engine light on
Common causes
Faulty throttle position sensor
Damaged wiring or connector
Pedal sensor not agreeing with the throttle
Control unit problem, less common
What to do
How to read code P1220
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1220 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (20) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1220 mean?
Series throttle control system malfunction. The control unit reported a fault in the system that operates the air throttle, described as a "series" system. This code is manufacturer-defined and I don't have solid information on the exact meaning for every make. In general it concerns the command and control of the electronic throttle.
Can I keep driving with code P1220 active?
With caution: limp mode possible, have it checked soon
Common causes — P1220
Dirty throttle body or faulty motor Faulty throttle position sensor Damaged wiring or connector Pedal sensor not agreeing with the throttle Control unit problem, less common
How do you fix code P1220?
Have the throttle body, sensors and wiring checked. If power is being limited, get it looked at soon and drive carefully.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction