P1231 — Fuel pump secondary circuit low, high-speed mode
| Meaning | P1231 is a manufacturer-defined code and I don't have reliable details on its exact meaning for every make. Going by the reference definition, the control unit read too low a signal in the fuel pump's secondary circuit while the pump runs at high speed, that is, when the engine demands more fuel. |
| Family | Powertrain (P) |
Typical symptoms
Poor pulling when accelerating or climbing
Sudden stalling
Check engine light on
Common causes
Oxidised or burnt connector
Faulty pump relay or fuse
Fuel pump drawing too much current or worn
Pump control module failure
What to do
How to read code P1231
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1231 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (31) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1231 mean?
Fuel pump secondary circuit low, high-speed mode. P1231 is a manufacturer-defined code and I don't have reliable details on its exact meaning for every make. Going by the reference definition, the control unit read too low a signal in the fuel pump's secondary circuit while the pump runs at high speed, that is, when the engine demands more fuel.
Can I keep driving with code P1231 active?
With caution: limp mode possible, have it checked soon
Common causes — P1231
Pump wiring with high resistance or a poor contact Oxidised or burnt connector Faulty pump relay or fuse Fuel pump drawing too much current or worn Pump control module failure
How do you fix code P1231?
First check the connectors, power cables and ground of the pump, because a weak contact under load is the most common cause. Avoid prolonged hard driving until it is sorted out, as the pump may not keep up with demand.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1230 — Fuel pump low-speed operation malfunction
- Next code: P1232 — Fuel pump speed primary circuit malfunction
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction