P1237 — Fuel pump secondary circuit malfunction
| Meaning | P1237 is a manufacturer-defined code and I don't have reliable details on its exact meaning for every make. Going by the reference definition, the control unit has detected a fault in the fuel pump's secondary circuit. The reference definition is identical to that of P1238, and without details on the make I cannot say for certain how the two codes differ. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or stalling
Hard starting
Check engine light on
Common causes
Faulty pump relay or fuse
Worn fuel pump
Pump control module failure
Insufficient ground or power supply
What to do
How to read code P1237
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1237 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (37) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1237 mean?
Fuel pump secondary circuit malfunction. P1237 is a manufacturer-defined code and I don't have reliable details on its exact meaning for every make. Going by the reference definition, the control unit has detected a fault in the fuel pump's secondary circuit. The reference definition is identical to that of P1238, and without details on the make I cannot say for certain how the two codes differ.
Can I keep driving with code P1237 active?
With caution: limp mode possible, have it checked soon
Common causes — P1237
Faulty secondary circuit wiring or connector Faulty pump relay or fuse Worn fuel pump Pump control module failure Insufficient ground or power supply
How do you fix code P1237?
First check the fuses, relays, connectors and grounds of the pump circuit. If the engine stalls or loses a lot of power, have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1236 — Fuel pump control out of range (variant)
- Next code: P1238 — Fuel pump secondary circuit fault (variant)
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction