P1246 — Alternator Load Input Failed
| Meaning | Alternator Load Input Failed. |
| Family | Powertrain (P) |
How to read code P1246
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1246 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (46) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1246 mean?
Alternator Load Input Failed.
Can I keep driving with code P1246 active?
With caution: limp mode possible, have it checked soon
How do you fix code P1246?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P1200 — Injector Control Circuit
- P1201 — Injector Circuit Open / Shorted - Cylinder #1
- P1202 — Injector Circuit Open / Shorted - Cylinder #2
- P1203 — Injector Circuit Open / Shorted - Cylinder #3
- P1204 — Injector Circuit Open / Shorted - Cylinder #4
- P1205 — Injector Circuit Open / Shorted - Cylinder #5
- P1206 — Injector Circuit Open / Shorted - Cylinder #6
- P1209 — Injector Control Pressure System Fault
- P1210 — Injector Control Pressure Above Expected Level
- P1211 — Injector Control Pressure Sensor Above / Below Desired
- P1212 — Injector Control Pressure Not Detected During Crank
- P1213 — Start Injector Circuit Malfunction