Skip to content
Fault code dictionary (DTC)

P1252 — Pedal correlation: PDS1 and LPDS, high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit compares several accelerator pedal sensors and here finds that PDS1 and LPDS do not agree, with a reading that is too high. P1252 is manufacturer-defined and I have no reliable information on exactly what LPDS means on your make. It is probably a second position signal used as a cross-check, but I can't confirm that.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Reduced or limited throttle response
Engine staying at low revs
Uneven acceleration
Limp mode

Common causes

Worn or faulty accelerator pedal sensor
Corroded or loose pedal connector
Damaged pedal wiring
Sensor power or ground problems
Faulty secondary sensor or switch (LPDS)

What to do

First check the pedal connector and the condition of the wires. Then have the pedal sensor values read with a diagnostic tool. Because the car may suddenly limit power, avoid overtaking and get it checked soon.

How to read code P1252

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P1252 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (52) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P1252 mean?

Pedal correlation: PDS1 and LPDS, high. The control unit compares several accelerator pedal sensors and here finds that PDS1 and LPDS do not agree, with a reading that is too high. P1252 is manufacturer-defined and I have no reliable information on exactly what LPDS means on your make. It is probably a second position signal used as a cross-check, but I can't confirm that.

Can I keep driving with code P1252 active?

With caution: limp mode possible, have it checked soon

Common causes — P1252

Worn or faulty accelerator pedal sensor Corroded or loose pedal connector Damaged pedal wiring Sensor power or ground problems Faulty secondary sensor or switch (LPDS)

How do you fix code P1252?

First check the pedal connector and the condition of the wires. Then have the pedal sensor values read with a diagnostic tool. Because the car may suddenly limit power, avoid overtaking and get it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes