P1256 — Pedal correlation: PDS1 and HPDS disagree
| Meaning | The control unit compares the accelerator pedal signals and finds that PDS1 and HPDS do not match. P1256 is manufacturer-defined and I have no reliable information on what HPDS stands for on your make. In practical terms, two signals that should report the same pedal position disagree. |
| Family | Powertrain (P) |
Typical symptoms
Limited throttle response
Low or unstable engine speed
Uneven acceleration
Limp mode
Common causes
Corroded or loose pedal connector
Damaged pedal wiring
Sensor power or ground problems
Faulty second sensor or switch (HPDS)
What to do
How to read code P1256
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1256 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (56) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1256 mean?
Pedal correlation: PDS1 and HPDS disagree. The control unit compares the accelerator pedal signals and finds that PDS1 and HPDS do not match. P1256 is manufacturer-defined and I have no reliable information on what HPDS stands for on your make. In practical terms, two signals that should report the same pedal position disagree.
Can I keep driving with code P1256 active?
With caution: limp mode possible, have it checked soon
Common causes — P1256
Worn or faulty accelerator pedal sensor Corroded or loose pedal connector Damaged pedal wiring Sensor power or ground problems Faulty second sensor or switch (HPDS)
How do you fix code P1256?
First check the pedal connector and wiring. Then have the sensor values read with a diagnostic tool. The pedal is a safety component: if the response is uncertain, get it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1255 — Pedal correlation: PDS2 and LPDS, low
- Next code: P1257 — Pedal correlation: PDS2 and HPDS disagree
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction