P1273 — Cylinder 3 injector circuit open
| Meaning | The control unit detects a break in the electrical circuit between the high side and the low side of the cylinder 3 injector, so it cannot drive it. The code is manufacturer-defined and the wording matches Ford engines with electronic injectors. On other makes the exact meaning must be verified. |
| Family | Powertrain (P) |
Typical symptoms
Engine running on fewer cylinders
Vibration and uneven running
Loss of power
Hard cold starting
Common causes
Broken or damaged wire in the harness
Open internal coil in the injector
Problem in the module that drives the injectors
Harness under the valve cover worn or damaged by heat
What to do
How to read code P1273
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1273 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (73) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1273 mean?
Cylinder 3 injector circuit open. The control unit detects a break in the electrical circuit between the high side and the low side of the cylinder 3 injector, so it cannot drive it. The code is manufacturer-defined and the wording matches Ford engines with electronic injectors. On other makes the exact meaning must be verified.
Can I keep driving with code P1273 active?
With caution: limp mode possible, have it checked soon
Common causes — P1273
Loose or corroded cylinder 3 injector connector Broken or damaged wire in the harness Open internal coil in the injector Problem in the module that drives the injectors Harness under the valve cover worn or damaged by heat
How do you fix code P1273?
Have the connector and wiring of the cylinder 3 injector checked first. You can drive short distances, but an engine with a cylinder not working is under strain, so do not put it off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1272 — Cylinder 2 injector circuit open
- Next code: P1274 — Cylinder 4 injector circuit open
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction