P1298 — Injector driver module (IDM) failure
| Meaning | The engine control unit reported a problem in the module that controls the injectors, called the IDM. This acronym is used by some manufacturers, notably on certain diesel engines, and its exact meaning changes from brand to brand. I don't have reliable information to tell you precisely what it detected on your car without knowing make and model. |
| Family | Powertrain (P) |
Typical symptoms
Engine not starting or starting with difficulty
Loss of power or limp mode
Engine suddenly stalling
Rough running
Abnormal exhaust smoke
Common causes
Corroded or loose module connector
Damaged wiring between module and injectors
Faulty injector driver module
Shorted injector stressing the module
What to do
How to read code P1298
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1298 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (2) points to fuel and air metering (injector circuit), and the last two (98) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1298 mean?
Injector driver module (IDM) failure. The engine control unit reported a problem in the module that controls the injectors, called the IDM. This acronym is used by some manufacturers, notably on certain diesel engines, and its exact meaning changes from brand to brand. I don't have reliable information to tell you precisely what it detected on your car without knowing make and model.
Can I keep driving with code P1298 active?
With caution: limp mode possible, have it checked soon
Common causes — P1298
Power or ground supply problem at the module Corroded or loose module connector Damaged wiring between module and injectors Faulty injector driver module Shorted injector stressing the module
How do you fix code P1298?
First check the battery, fuses, grounds and connectors of the module, because weak power supply can produce this kind of report. Then have the data read with a diagnostic tool specific to your brand. If the engine stalls or loses power, don't drive in heavy traffic.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1297 — Injector supply sides shorted together
- Next code: P1299 — Cylinder head overtemperature protection active
Related codes
- P1200 — Injector control circuit fault
- P1201 — Cylinder 1 injector circuit open or shorted
- P1202 — Cylinder 2 injector circuit open or shorted
- P1203 — Cylinder 3 injector circuit open or shorted
- P1204 — Cylinder 4 injector circuit open or shorted
- P1205 — Cylinder 5 injector circuit open or shorted
- P1206 — Cylinder 6 injector circuit open or shorted
- P1209 — Injector control pressure system fault
- P1210 — Injector control pressure above expected level
- P1211 — Injector control pressure sensor out of range
- P1212 — Injector control pressure not detected during cranking
- P1213 — Start injector circuit malfunction