P1349 — Fuel level sensor B circuit high
| Meaning | The control unit reads too high a voltage on the circuit of fuel level sensor B. The code is manufacturer-defined and I have no reliable information on exactly how each brand uses it. It usually points to a broken wire, an open contact or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
Level always high even with an almost empty tank
Inconsistent level readings
Check engine light on
Common causes
Disconnected or corroded connector
Faulty sensor in the tank
Missing sensor ground
Instrument cluster or control unit fault (rare)
What to do
How to read code P1349
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1349 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (3) points to ignition system or misfire, and the last two (49) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1349 mean?
Fuel level sensor B circuit high. The control unit reads too high a voltage on the circuit of fuel level sensor B. The code is manufacturer-defined and I have no reliable information on exactly how each brand uses it. It usually points to a broken wire, an open contact or a faulty sensor.
Can I keep driving with code P1349 active?
With caution: limp mode possible, have it checked soon
Common causes — P1349
Broken sensor wire Disconnected or corroded connector Faulty sensor in the tank Missing sensor ground Instrument cluster or control unit fault (rare)
How do you fix code P1349?
Be careful: the gauge may show more fuel than there really is, so refuel based on distance driven. Have the sensor ground, wiring and connector checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1348 — Fuel level sensor B circuit low
- Next code: P1350 — Fuel level sensor B intermittent or bypass line mo...
Related codes
- P1300 — Boost pressure calibration fault
- P1301 — Boost calibration reading too high
- P1302 — Boost calibration reading too low
- P1303 — EGR valve calibration fault
- P1304 — EGR calibration reading too high
- P1305 — EGR calibration reading too low
- P1306 — Kickdown relay: pull-in circuit fault
- P1307 — Kickdown relay: hold circuit fault
- P1308 — A/C compressor clutch circuit fault
- P1309 — Internal misfire-monitor circuit fault
- P1313 — Misfire rate high enough to damage catalyst - bank 1
- P1314 — Misfire rate high enough to damage catalyst - bank 2