P1354 — Ignition coil C primary circuit fault
| Meaning | The control unit detects a problem in the primary circuit, the low-voltage side that drives coil C. The code is manufacturer-defined and I have no reliable information on which cylinder coil C corresponds to for each brand. That coil may not produce the right spark. |
| Family | Powertrain (P) |
Typical symptoms
Misfires on one cylinder
Rough idle
Hesitation and loss of power
Hard starting
Common causes
Corroded or loose coil connector
Broken or shorted wiring
Faulty power or ground to the circuit
Ignition module or control unit fault (rare)
What to do
How to read code P1354
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1354 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (3) points to ignition system or misfire, and the last two (54) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1354 mean?
Ignition coil C primary circuit fault. The control unit detects a problem in the primary circuit, the low-voltage side that drives coil C. The code is manufacturer-defined and I have no reliable information on which cylinder coil C corresponds to for each brand. That coil may not produce the right spark.
Can I keep driving with code P1354 active?
With caution: limp mode possible, have it checked soon
Common causes — P1354
Faulty coil Corroded or loose coil connector Broken or shorted wiring Faulty power or ground to the circuit Ignition module or control unit fault (rare)
How do you fix code P1354?
Check the coil connector and wiring first, then the coil itself and the spark plug. If the light is flashing, reduce load and have it checked soon to protect the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1353 — Ignition coil B primary circuit fault
- Next code: P1355 — Ignition coil D primary circuit fault
Related codes
- P1300 — Boost pressure calibration fault
- P1301 — Boost calibration reading too high
- P1302 — Boost calibration reading too low
- P1303 — EGR valve calibration fault
- P1304 — EGR calibration reading too high
- P1305 — EGR calibration reading too low
- P1306 — Kickdown relay: pull-in circuit fault
- P1307 — Kickdown relay: hold circuit fault
- P1308 — A/C compressor clutch circuit fault
- P1309 — Internal misfire-monitor circuit fault
- P1313 — Misfire rate high enough to damage catalyst - bank 1
- P1314 — Misfire rate high enough to damage catalyst - bank 2