P1382 — Variable cam timing solenoid 1: circuit fault
| Meaning | The engine computer detected a fault in the electrical circuit of the first variable timing solenoid, the part that adjusts camshaft advance. The code is manufacturer-defined and I don't have reliable information on which bank or camshaft it refers to on your brand. The timing adjustment may therefore not work properly. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Higher fuel consumption
Hesitation when accelerating
Sometimes hard starting
Common causes
Damaged connector or wiring
Dirty or low engine oil
Clogged solenoid filter
Power or ground problem
Engine computer fault (rare)
What to do
How to read code P1382
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1382 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (3) points to ignition system or misfire, and the last two (82) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1382 mean?
Variable cam timing solenoid 1: circuit fault. The engine computer detected a fault in the electrical circuit of the first variable timing solenoid, the part that adjusts camshaft advance. The code is manufacturer-defined and I don't have reliable information on which bank or camshaft it refers to on your brand. The timing adjustment may therefore not work properly.
Can I keep driving with code P1382 active?
With caution: limp mode possible, have it checked soon
Common causes — P1382
Faulty or dirty solenoid Damaged connector or wiring Dirty or low engine oil Clogged solenoid filter Power or ground problem Engine computer fault (rare)
How do you fix code P1382?
Check the oil level and condition, then the solenoid connector and wiring. You can drive carefully to the workshop, but don't leave it too long: dirty or low oil can damage the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1381 — Variable cam timing overadvanced / misfire detecte...
- Next code: P1383 — Variable cam timing over-retarded (bank 1)
Related codes
- P1300 — Boost pressure calibration fault
- P1301 — Boost calibration reading too high
- P1302 — Boost calibration reading too low
- P1303 — EGR valve calibration fault
- P1304 — EGR calibration reading too high
- P1305 — EGR calibration reading too low
- P1306 — Kickdown relay: pull-in circuit fault
- P1307 — Kickdown relay: hold circuit fault
- P1308 — A/C compressor clutch circuit fault
- P1309 — Internal misfire-monitor circuit fault
- P1313 — Misfire rate high enough to damage catalyst - bank 1
- P1314 — Misfire rate high enough to damage catalyst - bank 2