P1413 — Secondary air system monitor circuit low input
| Meaning | P1413 is a manufacturer-defined code. The reference definition indicates a too-low signal from the SAI (secondary air) system monitor circuit. This abbreviation is typical of Ford engines; for other makes I have no reliable information. The control unit is reading a lower voltage than normal on that circuit. |
| Family | Powertrain (P) |
Typical symptoms
Higher emissions at inspection
Usually no obvious change in driving
Possible unusual noise from the air system at start-up
Failed emissions test
Common causes
Damaged or wet connector
Faulty monitor sensor
Faulty secondary air valve or pump
Leaks in the secondary air hoses
What to do
How to read code P1413
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1413 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (13) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1413 mean?
Secondary air system monitor circuit low input. P1413 is a manufacturer-defined code. The reference definition indicates a too-low signal from the SAI (secondary air) system monitor circuit. This abbreviation is typical of Ford engines; for other makes I have no reliable information. The control unit is reading a lower voltage than normal on that circuit.
Can I keep driving with code P1413 active?
With caution: limp mode possible, have it checked soon
Common causes — P1413
Sensor or monitor wiring shorted to ground Damaged or wet connector Faulty monitor sensor Faulty secondary air valve or pump Leaks in the secondary air hoses
How do you fix code P1413?
Check the wiring and connectors of the monitor circuit, looking for chafed wires or moisture. It is usually not urgent for driving, but it should not be left for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1411 — Secondary air system incorrect downstream flow
- Next code: P1414 — Secondary air system monitor circuit high input
Related codes
- P1400 — EGR differential pressure sensor: low signal
- P1401 — EGR differential pressure sensor: high signal
- P1402 — EGR metering orifice restricted
- P1403 — EGR differential pressure sensor hoses reversed
- P1404 — Intake air temp sensor circuit or EGR closed-position fault
- P1405 — Upstream EGR pressure sensor hose off or blocked
- P1406 — EGR position sensor performance fault
- P1407 — No EGR flow detected
- P1408 — EGR flow outside self-test range
- P1409 — EGR vacuum regulator control circuit fault
- P1411 — Secondary air system incorrect downstream flow
- P1414 — Secondary air system monitor circuit high input