P1538 — Intake manifold runner stuck open, bank 2
| Meaning | The control unit has detected that the variable intake runner system on bank 2 stays open and does not respond to the command. P1538 is manufacturer-defined (typically Ford); on other makes I do not have reliable information on its meaning. It applies to engines with two cylinder banks, such as V6 and V8 engines. |
| Family | Powertrain (P) |
Typical symptoms
Weak torque at low rpm
Less responsive acceleration
Unstable idle in some cases
Lower performance than normal
Common causes
Faulty actuator or runner motor
Cracked or disconnected vacuum hoses
Broken or worn linkage
Damaged actuator wiring or connector
Control unit (rare)
What to do
How to read code P1538
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1538 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (38) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1538 mean?
Intake manifold runner stuck open, bank 2. The control unit has detected that the variable intake runner system on bank 2 stays open and does not respond to the command. P1538 is manufacturer-defined (typically Ford); on other makes I do not have reliable information on its meaning. It applies to engines with two cylinder banks, such as V6 and V8 engines.
Can I keep driving with code P1538 active?
With caution: limp mode possible, have it checked soon
Common causes — P1538
Flaps or runner valves stuck from dirt and deposits Faulty actuator or runner motor Cracked or disconnected vacuum hoses Broken or worn linkage Damaged actuator wiring or connector Control unit (rare)
How do you fix code P1538?
Have the flap and actuator movement on bank 2 checked first, along with the vacuum hoses if fitted. You can drive carefully for short distances, but do not put it off: a broken flap can damage the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1537 — Intake manifold runner stuck open, bank 1
- Next code: P1539 — A/C clutch circuit overcurrent
Related codes
- P1500 — Vehicle speed sensor: intermittent signal
- P1501 — Vehicle speed sensor: out of range during self-test
- P1502 — Vehicle speed sensor: intermittent malfunction
- P1503 — Auxiliary speed sensor fault
- P1504 — Idle air control circuit malfunction
- P1505 — Idle air control at adaptive limit
- P1506 — Idle air control: idle speed too high
- P1507 — Idle air control: idle speed too low
- P1508 — Idle control system circuit open
- P1509 — Idle control system circuit shorted
- P1510 — Idle signal circuit malfunction
- P1511 — Idle switch (electronic throttle) circuit malfunction