P1644 — Fuel pump speed control circuit fault
| Meaning | The control unit has detected a fault in the circuit it uses to regulate fuel pump speed, found on systems where the pump doesn't always run at the same speed. P1644 is a manufacturer-defined code and the reference definition is typical of Ford and related vehicles; for other brands I have no reliable information. The pump may not be delivering adequate pressure. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power when accelerating
Engine jerking under load
Hard starting
Occasional stalling
Unusual pump noise
Common causes
Faulty pump control module
Worn fuel pump
Faulty relay or control resistor
Incorrect power or grounds
Internal fault in the control unit
What to do
How to read code P1644
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1644 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (6) points to computer and output circuits, and the last two (44) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1644 mean?
Fuel pump speed control circuit fault. The control unit has detected a fault in the circuit it uses to regulate fuel pump speed, found on systems where the pump doesn't always run at the same speed. P1644 is a manufacturer-defined code and the reference definition is typical of Ford and related vehicles; for other brands I have no reliable information. The pump may not be delivering adequate pressure.
Can I keep driving with code P1644 active?
With caution: limp mode possible, have it checked soon
Common causes — P1644
Damaged control circuit wiring or connector Faulty pump control module Worn fuel pump Faulty relay or control resistor Incorrect power or grounds Internal fault in the control unit
How do you fix code P1644?
Have the fuel pressure and the pump control circuit wiring checked. If the engine loses power or stalls, avoid using the car and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1643 — Fuel pump monitor circuit signal too low
- Next code: P1645 — Fuel pump resistor switch circuit fault
Related codes
- P1600 — KAM power loss: open circuit
- P1601 — Serial communication error between engine and transmission c...
- P1602 — Immobilizer to engine computer communication error
- P1603 — Engine computer EEPROM memory malfunction
- P1604 — Security code word not registered
- P1605 — Keep alive memory test failure
- P1606 — Engine computer control relay output circuit fault
- P1607 — Check engine light output circuit fault
- P1608 — Engine computer internal malfunction
- P1609 — Diagnostic lamp driver fault
- P1610 — P1610: SBDS diagnostic system interactive code
- P1611 — P1611: SBDS diagnostic system interactive code