P1813 — 4WD mode select circuit open
| Meaning | The control unit sees the 4WD mode selector circuit as open, as if a wire or contact were disconnected. The code is manufacturer-defined, so exact details depend on the make. The selector signal is not reaching the control unit. |
| Family | Powertrain (P) |
Typical symptoms
4WD mode does not respond to the selector
The display does not show the chosen mode
Four-wheel drive works only intermittently
Only two driven wheels even with the selector engaged
Common causes
Broken wire along the harness
Selector with worn internal contacts
Oxidation or corrosion at the contacts
Wiring damage after impacts or work under the body
What to do
How to read code P1813
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1813 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (8) points to transmission, and the last two (13) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1813 mean?
4WD mode select circuit open. The control unit sees the 4WD mode selector circuit as open, as if a wire or contact were disconnected. The code is manufacturer-defined, so exact details depend on the make. The selector signal is not reaching the control unit.
Can I keep driving with code P1813 active?
With caution: limp mode possible, have it checked soon
Common causes — P1813
Unplugged connector or loose terminal Broken wire along the harness Selector with worn internal contacts Oxidation or corrosion at the contacts Wiring damage after impacts or work under the body
How do you fix code P1813?
First check that the selector and transfer case connectors are fully seated and free of corrosion, then look for cut or stretched wires. You can drive, but four-wheel drive may be unreliable, so do not leave it unchecked for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1812 — 4WD mode select circuit: general fault
- Next code: P1814 — 4WD mode select circuit shorted to battery voltage
Related codes
- P1800 — Manufacturer-Specific Powertrain Fault Code P1800
- P1801 — Clutch interlock safety switch: open circuit
- P1802 — Clutch interlock safety switch: short to battery voltage
- P1803 — Clutch interlock safety switch: short to ground
- P1804 — 4WD High indicator circuit failure
- P1805 — 4WD High indicator: open circuit
- P1806 — 4WD High indicator: short to battery voltage
- P1807 — 4WD High indicator: short to ground
- P1808 — 4WD Low indicator circuit failure
- P1809 — 4WD Low indicator: open circuit
- P1810 — TFP valve position switch / 4WD Low indicator: short to batt...
- P1811 — 4WD Low indicator: short to ground