P1855 — Transfer case contact plate 'C' open circuit
| Meaning | The control module detected a break in the 'C' contact plate circuit of the transfer case: the signal is not getting through, as if a wire were cut or a contact had come loose. P1855 is manufacturer-specific and I don't have reliable information on its exact meaning for every brand. The reference wording indicates an open circuit on the contact group that reports the drive position. |
| Family | Powertrain (P) |
Typical symptoms
Four-wheel drive or low range not engaging
Missing or wrong 4x4 indication on the dash
Transmission in limp-home mode
Behavior that changes with vibration or moisture
Common causes
Broken wire or damaged terminal in the circuit
Faulty contact plate inside the transfer case
Wiring cut or pulled by an impact underneath
Internal control module fault (rare)
What to do
How to read code P1855
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1855 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (8) points to transmission, and the last two (55) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1855 mean?
Transfer case contact plate 'C' open circuit. The control module detected a break in the 'C' contact plate circuit of the transfer case: the signal is not getting through, as if a wire were cut or a contact had come loose. P1855 is manufacturer-specific and I don't have reliable information on its exact meaning for every brand. The reference wording indicates an open circuit on the contact group that reports the drive position.
Can I keep driving with code P1855 active?
With caution: limp mode possible, have it checked soon
Common causes — P1855
Transfer case connector unplugged, loose or corroded Broken wire or damaged terminal in the circuit Faulty contact plate inside the transfer case Wiring cut or pulled by an impact underneath Internal control module fault (rare)
How do you fix code P1855?
First make sure the transfer case connector is fully seated and clean, then check the condition of the wiring. It is not an emergency, but the four-wheel drive may not engage, so drive carefully on difficult surfaces.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1854 — Transfer case contact plate 'C' circuit fault
- Next code: P1856 — Transfer case contact plate 'C' short to battery v...
Related codes
- P1800 — Manufacturer-Specific Powertrain Fault Code P1800
- P1801 — Clutch interlock safety switch: open circuit
- P1802 — Clutch interlock safety switch: short to battery voltage
- P1803 — Clutch interlock safety switch: short to ground
- P1804 — 4WD High indicator circuit failure
- P1805 — 4WD High indicator: open circuit
- P1806 — 4WD High indicator: short to battery voltage
- P1807 — 4WD High indicator: short to ground
- P1808 — 4WD Low indicator circuit failure
- P1809 — 4WD Low indicator: open circuit
- P1810 — TFP valve position switch / 4WD Low indicator: short to batt...
- P1811 — 4WD Low indicator: short to ground