P1860 — Contact plate 'D' short to battery or torque converter solenoid fault
| Meaning | The reference wording combines two meanings: a short to positive on the 'D' contact plate circuit of the transfer case, or an electrical problem on the modulated solenoid that controls the torque converter lock-up in an automatic transmission. P1860 is manufacturer-specific and I don't have reliable information on which of the two applies to your vehicle, so brand-specific documentation is needed. |
| Family | Powertrain (P) |
Typical symptoms
Automatic gearbox overheating or jerking at steady speed
Fuel use that seems higher than usual
Four-wheel drive or low range not engaging
Transmission in limp-home mode
Common causes
Corroded or wet connector at the transmission or transfer case
Torque converter solenoid with a shorted winding
Faulty contact plate inside the transfer case
Internal transmission control module fault (rare)
What to do
How to read code P1860
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P1860 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (8) points to transmission, and the last two (60) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1860 mean?
Contact plate 'D' short to battery or torque converter solenoid fault. The reference wording combines two meanings: a short to positive on the 'D' contact plate circuit of the transfer case, or an electrical problem on the modulated solenoid that controls the torque converter lock-up in an automatic transmission. P1860 is manufacturer-specific and I don't have reliable information on which of the two applies to your vehicle, so brand-specific documentation is needed.
Can I keep driving with code P1860 active?
With caution: limp mode possible, have it checked soon
Common causes — P1860
Wire in the circuit with worn insulation touching a live cable Corroded or wet connector at the transmission or transfer case Torque converter solenoid with a shorted winding Faulty contact plate inside the transfer case Internal transmission control module fault (rare)
How do you fix code P1860?
First have the diagnosis confirm which of the two circuits is involved on your brand, then check the related wiring and connectors. It is not an immediate emergency, but an automatic gearbox that jerks or overheats should be looked at soon to avoid making it worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1859 — Transfer case contact plate 'D' open circuit
- Next code: P1861 — Transfer case contact plate 'D' short to ground
Related codes
- P1800 — Manufacturer-Specific Powertrain Fault Code P1800
- P1801 — Clutch interlock safety switch: open circuit
- P1802 — Clutch interlock safety switch: short to battery voltage
- P1803 — Clutch interlock safety switch: short to ground
- P1804 — 4WD High indicator circuit failure
- P1805 — 4WD High indicator: open circuit
- P1806 — 4WD High indicator: short to battery voltage
- P1807 — 4WD High indicator: short to ground
- P1808 — 4WD Low indicator circuit failure
- P1809 — 4WD Low indicator: open circuit
- P1810 — TFP valve position switch / 4WD Low indicator: short to batt...
- P1811 — 4WD Low indicator: short to ground