P1873 — 4WD axle lock lamp circuit shorted to battery
| Meaning | The control module measured battery-level voltage on the axle lock lamp circuit where it should not be. This means the lamp wire is touching a live supply or the driver has stuck on. It is a manufacturer-defined code and the description follows the reference definition, typical of Ford vehicles. |
| Family | Powertrain (P) |
Typical symptoms
Lamp on even with 4WD disengaged
Check engine lamp on
4WD works normally but the indication is wrong
Common causes
Damaged connector or water inside it
Control module output failure
Axle lock switch shorted
Poorly done earlier wiring repair
What to do
How to read code P1873
This is an informational entry: it normally does not limit how the vehicle works.
The code P1873 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (8) points to transmission, and the last two (73) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P1873 mean?
4WD axle lock lamp circuit shorted to battery. The control module measured battery-level voltage on the axle lock lamp circuit where it should not be. This means the lamp wire is touching a live supply or the driver has stuck on. It is a manufacturer-defined code and the description follows the reference definition, typical of Ford vehicles.
Can I keep driving with code P1873 active?
With caution: limp mode possible, have it checked soon
Common causes — P1873
Wire insulation worn through and touching a live cable Damaged connector or water inside it Control module output failure Axle lock switch shorted Poorly done earlier wiring repair
How do you fix code P1873?
Have the lamp wiring inspected visually, especially where it runs near hot or moving parts and at the connectors under the body. Avoid relying on 4WD until you know the control is trustworthy. It rarely leaves you stranded, but a short to battery left alone can damage the module.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P1872 — 4WD axle lock lamp circuit fault
- Next code: P1874 — Automatic transmission Hall sensor power circuit f...
Related codes
- P1800 — Manufacturer-Specific Powertrain Fault Code P1800
- P1801 — Clutch interlock safety switch: open circuit
- P1802 — Clutch interlock safety switch: short to battery voltage
- P1803 — Clutch interlock safety switch: short to ground
- P1804 — 4WD High indicator circuit failure
- P1805 — 4WD High indicator: open circuit
- P1806 — 4WD High indicator: short to battery voltage
- P1807 — 4WD High indicator: short to ground
- P1808 — 4WD Low indicator circuit failure
- P1809 — 4WD Low indicator: open circuit
- P1810 — TFP valve position switch / 4WD Low indicator: short to batt...
- P1811 — 4WD Low indicator: short to ground