P2115 — Throttle/pedal sensor D: minimum stop performance
| Meaning | The engine computer checks that the sensor labelled D, on the throttle or the pedal, gives the correct value at the minimum position. The value read is not the expected one or does not agree with the other sensors. The letter D is assigned by the manufacturer and many cars do not use it: without your make's diagram I cannot say for certain which sensor it is. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Unnatural pedal response
Reduced power or limp mode
Occasional stalling with the pedal released
Common causes
Dirty throttle body that does not close properly
Connector or wiring with poor contact
Throttle relearn needed
Accelerator pedal with a faulty sensor
Faulty engine control unit (rare)
What to do
How to read code P2115
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2115 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (15) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2115 mean?
Throttle/pedal sensor D: minimum stop performance. The engine computer checks that the sensor labelled D, on the throttle or the pedal, gives the correct value at the minimum position. The value read is not the expected one or does not agree with the other sensors. The letter D is assigned by the manufacturer and many cars do not use it: without your make's diagram I cannot say for certain which sensor it is.
Can I keep driving with code P2115 active?
With caution: limp mode possible, have it checked soon
Common causes — P2115
Sensor D out of calibration or worn Dirty throttle body that does not close properly Connector or wiring with poor contact Throttle relearn needed Accelerator pedal with a faulty sensor Faulty engine control unit (rare)
How do you fix code P2115?
Have the sensor D signal checked with the diagnostic tool at pedal released, then check connectors and throttle cleanliness. If the car is in limp mode, avoid long trips and heavy traffic.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2114 — Throttle/pedal sensor C: minimum stop performance
- Next code: P2116 — Throttle/pedal sensor E: minimum stop performance
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance