Skip to content
Fault code dictionary (DTC)

P2130 — Pedal/throttle sensor F: circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine control unit found an electrical problem in the circuit of the pedal or throttle position sensor called "F" in the standard. The signal is not what it expects and the unit can no longer trust the information. Which sensor is "F" depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Reduced power or limp mode
Accelerator responding poorly
Uneven idle
Engine that will not rev past a certain limit

Common causes

Damaged or corroded sensor connector
Wire broken, shorted or with damaged insulation
Faulty pedal or throttle sensor
Irregular sensor supply or ground
Control unit fault (rare)

What to do

Check the pedal and throttle connector and wiring, looking for damaged wires, dirty terminals or moisture. If the car is in limp mode, use it only to reach a workshop, since the accelerator response can drop suddenly.

How to read code P2130

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2130 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (30) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2130 mean?

Pedal/throttle sensor F: circuit fault. The engine control unit found an electrical problem in the circuit of the pedal or throttle position sensor called "F" in the standard. The signal is not what it expects and the unit can no longer trust the information. Which sensor is "F" depends on the manufacturer.

Can I keep driving with code P2130 active?

With caution: limp mode possible, have it checked soon

Common causes — P2130

Damaged or corroded sensor connector Wire broken, shorted or with damaged insulation Faulty pedal or throttle sensor Irregular sensor supply or ground Control unit fault (rare)

How do you fix code P2130?

Check the pedal and throttle connector and wiring, looking for damaged wires, dirty terminals or moisture. If the car is in limp mode, use it only to reach a workshop, since the accelerator response can drop suddenly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes