P2147 — Injector group A supply voltage circuit: low
| Meaning | The control unit has measured a supply voltage that is too low on the circuit of injector group "A". The injectors may therefore not open correctly. Which cylinders are in group A depends on the engine and the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Irregular idle
Hesitation or lack of power
Hard starting
Abnormal consumption and smoke
Common causes
Ground or wiring with high resistance
Corroded connector
Supply wire touching ground
Shorted injector
Faulty engine control unit (rare)
What to do
How to read code P2147
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2147 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (47) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2147 mean?
Injector group A supply voltage circuit: low. The control unit has measured a supply voltage that is too low on the circuit of injector group "A". The injectors may therefore not open correctly. Which cylinders are in group A depends on the engine and the manufacturer.
Can I keep driving with code P2147 active?
With caution: limp mode possible, have it checked soon
Common causes — P2147
Weak battery or charging system Ground or wiring with high resistance Corroded connector Supply wire touching ground Shorted injector Faulty engine control unit (rare)
How do you fix code P2147?
First check the battery, terminals and engine grounds, then the injector connectors and wiring. Have it checked soon: irregular combustion can stress the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2146 — Injector group A supply voltage circuit: open
- Next code: P2148 — Injector group A supply voltage circuit: high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance