Skip to content
Fault code dictionary (DTC)

P214B — SCR inlet temperature too high during filter regeneration

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningDuring particulate filter regeneration (when the engine burns off accumulated soot) the control unit has detected that the gas entering the SCR catalyst exceeds the temperature limit. The SCR catalyst reduces nitrogen oxides using AdBlue on diesels.
FamilyPowertrain (P)

Typical symptoms

Check engine or particulate filter warning light on
Warning message on the dashboard
Regeneration repeating often
Cooling fan running for a long time
Loss of power or limited engine

Common causes

Exhaust temperature sensor reading incorrectly
Regeneration managed abnormally, with temperatures too high
Particulate filter heavily loaded with soot
Injectors or injection sending too much fuel into the exhaust
Leaks in the exhaust line
Fault in the SCR system or its management (rare)

What to do

Check whether other codes are stored on the particulate filter, temperature sensors and injection. If warnings appear or power drops, have it diagnosed soon and do not repeatedly interrupt regeneration cycles.

How to read code P214B

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P214B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (4B) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P214B mean?

SCR inlet temperature too high during filter regeneration. During particulate filter regeneration (when the engine burns off accumulated soot) the control unit has detected that the gas entering the SCR catalyst exceeds the temperature limit. The SCR catalyst reduces nitrogen oxides using AdBlue on diesels.

Can I keep driving with code P214B active?

With caution: limp mode possible, have it checked soon

Common causes — P214B

Exhaust temperature sensor reading incorrectly Regeneration managed abnormally, with temperatures too high Particulate filter heavily loaded with soot Injectors or injection sending too much fuel into the exhaust Leaks in the exhaust line Fault in the SCR system or its management (rare)

How do you fix code P214B?

Check whether other codes are stored on the particulate filter, temperature sensors and injection. If warnings appear or power drops, have it diagnosed soon and do not repeatedly interrupt regeneration cycles.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes