P214E — Reductant (AdBlue) pump A: motor current too high
| Meaning | The SCR control unit measured that the motor of the pump that feeds AdBlue (urea) is drawing more current than normal. This usually means the pump is struggling to turn, or there is a short or abnormal resistance in its electrical circuit. If it persists, the system may not dose AdBlue properly. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about an emissions system fault
Possible power limitation on some vehicles
Higher nitrogen oxide emissions, which you cannot feel while driving
On some models, a warning that starting may be blocked after a set distance
Common causes
Urea crystals blocking the pump or its lines
Frozen, contaminated or wrong-spec AdBlue
Pump wiring or connector shorted or corroded
Faulty dosing module or SCR control unit
What to do
How to read code P214E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P214E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (4E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P214E mean?
Reductant (AdBlue) pump A: motor current too high. The SCR control unit measured that the motor of the pump that feeds AdBlue (urea) is drawing more current than normal. This usually means the pump is struggling to turn, or there is a short or abnormal resistance in its electrical circuit. If it persists, the system may not dose AdBlue properly.
Can I keep driving with code P214E active?
With caution: limp mode possible, have it checked soon
Common causes — P214E
Worn pump or a motor that sticks Urea crystals blocking the pump or its lines Frozen, contaminated or wrong-spec AdBlue Pump wiring or connector shorted or corroded Faulty dosing module or SCR control unit
How do you fix code P214E?
First check the quality and level of the AdBlue and look for white crystal deposits around the pump, hoses and connectors. The car can usually be driven, but don't leave it for long: on many vehicles a lasting SCR fault leads to power limits or a no-start condition.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P214D — SCR outlet temperature too high during filter rege...
- Next code: P214F — Reductant (AdBlue) heater A: current too high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance