P2153 — Fuel injector group C: supply voltage too low
| Meaning | The control unit measured too low a voltage on the supply of injector group C. Which injectors belong to it is defined by the manufacturer. With weak voltage the injectors may work poorly. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Hesitation when accelerating
Slow or hard starting
Possible limp mode
Common causes
Weak battery or poor grounds
Problem with the supply fuse or relay
Wiring partly shorted to ground
Faulty engine control unit
What to do
How to read code P2153
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2153 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (53) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2153 mean?
Fuel injector group C: supply voltage too low. The control unit measured too low a voltage on the supply of injector group C. Which injectors belong to it is defined by the manufacturer. With weak voltage the injectors may work poorly.
Can I keep driving with code P2153 active?
With caution: limp mode possible, have it checked soon
Common causes — P2153
High-resistance contacts in the wiring or connectors Weak battery or poor grounds Problem with the supply fuse or relay Wiring partly shorted to ground Faulty engine control unit
How do you fix code P2153?
First verify the battery and grounds, then the fuses, relay and connectors of the injector supply. If symptoms are strong, limit use of the car until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2152 — Fuel injector group C: supply circuit open
- Next code: P2154 — Fuel injector group C: supply voltage too high
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance