P2155 — Fuel injector group D: supply circuit open
| Meaning | The control unit sees no continuity in the circuit that powers injector group D, as if there were a break. Which injectors are in group D is set by the manufacturer. The injectors involved may be left without power. |
| Family | Powertrain (P) |
Typical symptoms
Engine running on fewer cylinders
Vibration and rough running
Hard or impossible starting
Obvious loss of power
Common causes
Blown fuse
Supply relay that does not close
Corroded or loose terminals
Faulty engine control unit
What to do
How to read code P2155
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2155 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (55) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2155 mean?
Fuel injector group D: supply circuit open. The control unit sees no continuity in the circuit that powers injector group D, as if there were a break. Which injectors are in group D is set by the manufacturer. The injectors involved may be left without power.
Can I keep driving with code P2155 active?
With caution: limp mode possible, have it checked soon
Common causes — P2155
Broken wire or unplugged connector Blown fuse Supply relay that does not close Corroded or loose terminals Faulty engine control unit
How do you fix code P2155?
Check the fuse, relay and connectors of the injector supply right away. If the engine is not running on all cylinders, avoid driving for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2154 — Fuel injector group C: supply voltage too high
- Next code: P2156 — Fuel injector group D: supply voltage too low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance