P215D — Reductant (AdBlue) pump B: stuck on
| Meaning | The SCR control unit sees reductant pump B as always running, even when it should stop. It may be a fault in the electrical command or a control that cannot switch it off. I can't say for sure which pump is B on your car, as that depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about an emissions system fault
Abnormal AdBlue consumption
Continuous pump noise in some cases
Possible power limitation on some vehicles
Common causes
Wiring shorted to the supply
Pump with jammed or faulty internal parts
Urea crystals disturbing operation
Faulty SCR control unit
What to do
How to read code P215D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P215D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (5D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P215D mean?
Reductant (AdBlue) pump B: stuck on. The SCR control unit sees reductant pump B as always running, even when it should stop. It may be a fault in the electrical command or a control that cannot switch it off. I can't say for sure which pump is B on your car, as that depends on the manufacturer.
Can I keep driving with code P215D active?
With caution: limp mode possible, have it checked soon
Common causes — P215D
Stuck relay or driver commanding the pump Wiring shorted to the supply Pump with jammed or faulty internal parts Urea crystals disturbing operation Faulty SCR control unit
How do you fix code P215D?
First check the wiring, connectors and relay of the pump, and look for urea deposits. Better not to delay, because a pump that never stops wears out and can drain the battery.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P215C — Output shaft speed does not match wheel speed
- Next code: P215E — Reductant (AdBlue) heater D: current too low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance