P216A — Fuel injector group E: supply voltage missing or open circuit
| Meaning | The control unit has found a problem in the circuit that feeds supply voltage to the group E fuel injectors: the voltage is missing or the circuit is broken. How the cylinders are split into groups, and which belong to group E, is decided by the manufacturer. I have no reliable details for a specific make. |
| Family | Powertrain (P) |
Typical symptoms
Engine running on fewer cylinders or shaking
Lack of power
Hard starting or engine that will not start
Unstable idle or stalling
Common causes
Faulty injector supply fuse or relay
Poorly connected or corroded ground or supply
Injector with a shorted or open coil
Injector driver failure in the control unit (rare)
What to do
How to read code P216A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P216A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (6A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P216A mean?
Fuel injector group E: supply voltage missing or open circuit. The control unit has found a problem in the circuit that feeds supply voltage to the group E fuel injectors: the voltage is missing or the circuit is broken. How the cylinders are split into groups, and which belong to group E, is decided by the manufacturer. I have no reliable details for a specific make.
Can I keep driving with code P216A active?
With caution: limp mode possible, have it checked soon
Common causes — P216A
Damaged injector supply connector or wiring Faulty injector supply fuse or relay Poorly connected or corroded ground or supply Injector with a shorted or open coil Injector driver failure in the control unit (rare)
How do you fix code P216A?
First check the fuses, relays and injector connectors. Then a diagnostic tool is used to see which cylinders are involved. If the engine shakes or loses power, do not keep pushing it: poorly working injectors can damage the engine or the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2169 — Exhaust pressure regulator vent solenoid: open cir...
- Next code: P216B — Fuel injector group E: supply voltage too low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance