P216C — Fuel injector group E: supply voltage too high
| Meaning | The control unit measures a higher voltage than expected on the supply circuit of the group E fuel injectors. How the cylinders are split into groups, and which belong to group E, is decided by the manufacturer. I have no reliable details for a specific make. |
| Family | Powertrain (P) |
Typical symptoms
Engine running on fewer cylinders or shaking
Lack of power or jerking
Unstable idle
Engine stalling or not starting
Common causes
Charging system problem producing excessive voltage
Damaged wiring or connector
Faulty injector supply relay
Injector driver failure in the control unit (rare)
What to do
How to read code P216C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P216C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (6C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P216C mean?
Fuel injector group E: supply voltage too high. The control unit measures a higher voltage than expected on the supply circuit of the group E fuel injectors. How the cylinders are split into groups, and which belong to group E, is decided by the manufacturer. I have no reliable details for a specific make.
Can I keep driving with code P216C active?
With caution: limp mode possible, have it checked soon
Common causes — P216C
Supply wire touching another line at a higher voltage Charging system problem producing excessive voltage Damaged wiring or connector Faulty injector supply relay Injector driver failure in the control unit (rare)
How do you fix code P216C?
Have the alternator charging voltage and the condition of the injector wiring checked. Then move on to the relay and connectors. Excess voltage can damage electronics, so do not delay the check for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P216B — Fuel injector group E: supply voltage too low
- Next code: P216D — Fuel injector group F: supply voltage missing or o...
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance