P2189 — System too lean at idle, bank 2
| Meaning | The control unit sees that, with the engine idling, bank 2 is getting too much air for the amount of fuel. Bank 2 is the half of the engine opposite the one with cylinder number 1. It has already added the maximum fuel allowed without managing to correct it. |
| Family | Powertrain (P) |
Typical symptoms
Rough or hunting idle
Engine stalling at low revs
Hesitation when pulling away
Higher than normal fuel consumption
Common causes
Insufficient fuel pressure
Dirty or weak injectors
Dirty mass airflow sensor
Faulty bank 2 oxygen sensor
Exhaust leak ahead of the sensor
What to do
How to read code P2189
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2189 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (89) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2189 mean?
System too lean at idle, bank 2. The control unit sees that, with the engine idling, bank 2 is getting too much air for the amount of fuel. Bank 2 is the half of the engine opposite the one with cylinder number 1. It has already added the maximum fuel allowed without managing to correct it.
Can I keep driving with code P2189 active?
Yes, no known limitation
Common causes — P2189
Air leak from hoses, gaskets or manifold on the bank 2 side Insufficient fuel pressure Dirty or weak injectors Dirty mass airflow sensor Faulty bank 2 oxygen sensor Exhaust leak ahead of the sensor
How do you fix code P2189?
Look first for intake air leaks, especially on the bank 2 side: they show up more at idle. Don't leave it for long, as a lean mixture overheats the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2188 — System too rich at idle, bank 1
- Next code: P218A — Throttle actuator B idle position not learned
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance