P219A — Air-fuel ratio imbalance, bank 1
| Meaning | The control unit has detected that the mixture across the cylinders on bank 1 (the side that includes cylinder 1) is uneven: at least one cylinder is getting more or less fuel than the others. It works this out from how the oxygen sensor signal varies. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or vibration
Loss of power
Rising fuel consumption
Possible misfires
Unusual exhaust smell
Common causes
Air leak near a cylinder (intake manifold gasket)
Worn spark plug or coil
Uneven compression or a valve not sealing properly
Slow or faulty bank 1 oxygen sensor
Incorrect fuel pressure
What to do
How to read code P219A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P219A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (9A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P219A mean?
Air-fuel ratio imbalance, bank 1. The control unit has detected that the mixture across the cylinders on bank 1 (the side that includes cylinder 1) is uneven: at least one cylinder is getting more or less fuel than the others. It works this out from how the oxygen sensor signal varies.
Can I keep driving with code P219A active?
With caution: limp mode possible, have it checked soon
Common causes — P219A
Dirty, blocked or leaking injector on a cylinder of the bank Air leak near a cylinder (intake manifold gasket) Worn spark plug or coil Uneven compression or a valve not sealing properly Slow or faulty bank 1 oxygen sensor Incorrect fuel pressure
How do you fix code P219A?
Have the scan tool read misfires and per-cylinder mixture corrections, then check the spark plugs, coils and injectors on bank 1. Avoid running the engine for long with misfires, as they can damage the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2199 — Intake air temperature sensors 1 and 2 mismatch
- Next code: P219B — Air-fuel ratio imbalance, bank 2
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance