P219C — Air-fuel ratio imbalance, cylinder 1
| Meaning | The control unit has singled out cylinder 1 as getting a different mixture from the others, either too rich or too lean. The engine compensates as best it can, but that cylinder runs less smoothly and can upset overall operation. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or vibration
Loss of power
Rising fuel consumption
Possible misfires on cylinder 1
Unusual exhaust smell
Common causes
Air leak near cylinder 1
Worn cylinder 1 spark plug or coil
Low compression or a valve not sealing properly
Damaged injector wiring or connector
Slow or faulty oxygen sensor on that bank
What to do
How to read code P219C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P219C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (9C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P219C mean?
Air-fuel ratio imbalance, cylinder 1. The control unit has singled out cylinder 1 as getting a different mixture from the others, either too rich or too lean. The engine compensates as best it can, but that cylinder runs less smoothly and can upset overall operation.
Can I keep driving with code P219C active?
With caution: limp mode possible, have it checked soon
Common causes — P219C
Cylinder 1 injector dirty, blocked or leaking Air leak near cylinder 1 Worn cylinder 1 spark plug or coil Low compression or a valve not sealing properly Damaged injector wiring or connector Slow or faulty oxygen sensor on that bank
How do you fix code P219C?
Have the cylinder 1 spark plug, coil and injector checked, even swapping parts with another cylinder to see whether the problem moves. If the engine misfires, avoid running it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P219B — Air-fuel ratio imbalance, bank 2
- Next code: P219D — Air-fuel ratio imbalance, cylinder 2
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance