P21A2 — Cylinder 7 air-fuel mixture imbalance
| Meaning | The engine computer found that the air-fuel mixture in cylinder 7 differs abnormally from the other cylinders. Cylinder 7 is running either too rich or too lean compared with the rest. The code does not identify the faulty part, it only narrows down the search. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle or engine vibration
Loss of power when accelerating
Higher fuel consumption than usual
Smell of unburned fuel from the exhaust
Hesitation or jerking while driving
Common causes
Air leak or bad gasket near cylinder 7
Worn spark plug or ignition coil on cylinder 7
Low compression in cylinder 7 (valve or piston rings)
Oxygen sensor reading incorrectly
Damaged wiring or connector at the injector
What to do
How to read code P21A2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21A2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (A2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21A2 mean?
Cylinder 7 air-fuel mixture imbalance. The engine computer found that the air-fuel mixture in cylinder 7 differs abnormally from the other cylinders. Cylinder 7 is running either too rich or too lean compared with the rest. The code does not identify the faulty part, it only narrows down the search.
Can I keep driving with code P21A2 active?
With caution: limp mode possible, have it checked soon
Common causes — P21A2
Cylinder 7 injector dirty, leaking or delivering too little Air leak or bad gasket near cylinder 7 Worn spark plug or ignition coil on cylinder 7 Low compression in cylinder 7 (valve or piston rings) Oxygen sensor reading incorrectly Damaged wiring or connector at the injector
How do you fix code P21A2?
First look at whether the computer also saved misfire or fuel trim codes, because they show whether the cylinder is rich or lean. Then check the spark plug, coil and injector of cylinder 7 and look for air leaks. Using the car for long in this condition is not advisable, to avoid damaging the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21A1 — Cylinder 6 air-fuel mixture imbalance
- Next code: P21A3 — Cylinder 8 air-fuel mixture imbalance
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance