Skip to content
Fault code dictionary (DTC)

P21AB — Reductant (AdBlue) level sensor B signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer measured a higher than normal voltage on the circuit of AdBlue (urea) level sensor B. This usually points to a broken wire, an open contact, a short to the supply or a faulty sensor. Which sensor counts as B depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine or AdBlue warning light on
AdBlue gauge at maximum or not working
AdBlue level never goes down
Warnings about the range of the emissions system
On some models, power limitation

Common causes

Sensor wire broken
Connector unplugged or with an open contact
Short to supply voltage in the wiring
Faulty level sensor
Problem in the AdBlue system control unit

What to do

First check that the sensor connector is fully seated and free of corrosion, and that the wires are not cut or stretched. Then the sensor itself should be tested. It is worth doing this soon, because without a reliable reading the system cannot manage the urea properly.

How to read code P21AB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P21AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (AB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P21AB mean?

Reductant (AdBlue) level sensor B signal too high. The engine computer measured a higher than normal voltage on the circuit of AdBlue (urea) level sensor B. This usually points to a broken wire, an open contact, a short to the supply or a faulty sensor. Which sensor counts as B depends on the manufacturer.

Can I keep driving with code P21AB active?

With caution: limp mode possible, have it checked soon

Common causes — P21AB

Sensor wire broken Connector unplugged or with an open contact Short to supply voltage in the wiring Faulty level sensor Problem in the AdBlue system control unit

How do you fix code P21AB?

First check that the sensor connector is fully seated and free of corrosion, and that the wires are not cut or stretched. Then the sensor itself should be tested. It is worth doing this soon, because without a reliable reading the system cannot manage the urea properly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes